ES-1 Emergency Stop & Accessories

Product Code: ES-1, DLS-1, DLS-2 & HB-1
ES-1 Emergency Stop & Accessories
  • Description and Uses
  • Installation Sheets & Templates

ES-1 Emergency Stop & Accessories

Emergency Rescue Hardware Set - Application

The Emergency Rescue Hardware Set can be used on any internal door designed for double action operation, with a maximum weight of 65 kilos – dictated by the jamb mounted pivot set.

The Building Regulations Part M – Access To & Use of Buildings M1/M3 Buildings other than dwellings. Section 5 – Sanitary accommodation in buildings other than dwellings.

The above mentioned section of Approved Document M includes design considerations and provisions to address the issues mentioned in the introduction. Specifically: “5.4 e. WC compartment doors, and doors to wheelchair-accessible unisex toilets, changing rooms or shower rooms have an emergency release mechanism so that they are capable of being opened outwards, from the outside, in case of emergency.”

ES-1 Emergency Stop

Features & Benefits

  • Pullman Type Latch Bolt with Rubber Bumper Insert –Finger tip release
  • Spring Action Stop – Stop release resets automatically

The ES-1 is a strongly built buffered stop that can be pushed out of the way quickly and easily, without special tools, allowing normally in-swinging doors to open in the opposite direction.

Default Specification

Surface Plate - 114mmx 41mm
Bolt Height - 51mm
Case - 54mm x 33mm

How to Specify or Order

ES-1 Emergency Stop

Finishes

US26D - Satin Chrome
US3 - Polished Brass

DLS-1 & DLS-2 Double Lipped Strike 

These protection plates are designed to be used with the emergency rescue hardware set allowing offset and centre hung doors to be opened in both directions without damaging the door frame

The DLS-1 is designed for offset hung doors and suits frames to 146mm wide

DLS-1 Double Lipped Strike

The DLS-2 is designed for centre hung doors and suits frames to 146mm wide

DLS-2 Double Lipped Strike

Custom double lipped strikes can be fabricated to suit any frame and door detail. 

How to Specify or Order

DLS-1 Double Lipped Strike
DLS-2 Double Lipped Strike

Finishes

US26D - Satin Chrome
US3 - Polished Brass

HB-1 Hold Back for ES-1

The holdback plate attaches to the ES-1 faceplate and holds the door stop in the depressed position allowing the door to work in ‘double-action’ mode.

   HB-1 Hold Back for ES-1

How to Specify or Order

HB-1 Hold Back

Finishes

US26D - Satin Chrome
US3 - Polished Brass

 

Associated Products

Copyright © 2017 Relcross Ltd  |  All Rights Reserved
Relcross Ltd
Hambleton Avenue
Devizes
Wiltshire
SN10 2RT

t: 01380 729 600

w: www.relcross.co.uk
e: j.livesey@relcross.co.uk